First turn the sprinkler on before you begin adjusting the head. In this video i show you how to make adjustments to your hunter sprinkler heads including left and right stops water pressure and spray nozzle.
Move the head to the right side of the spray area and adjust the other clamp in the same way.
How to adjust hunter sprinkler heads distance.
Insert the plastic head of the wench and rotate the socket clockwise to increase the arc.
Next turn the adjustment screw by using a small flat head.
Select the correct nozzle for head to head coverage.
Step 2 turn the adjustment screw.
How to adjust a pop up sprinkler head step 1 turn the sprinkler on.
Install the nozzle by pressing it into the opening until it is flush with the rotor body.
Locate the sprinklers dial for water stream adjustment.
That dial is on top of some impact sprinkler models.
Turn the dial toward the minimum distance setting to reduce the distance the water travels.
Do the opposite to decrease the arc of the pop up sprinkler head.
Next the right hand limit of travel must be found.
How to adjust a hunter rotor.
Turn the collar that locks the rotor.
Step 1 determine sprinkler head type.
Radius can be reduced up to 25.
Youll need a tool see link below to adjust the.
The dial adjustment lowers the distance control flap reducing the water sprays distance.
Insert the steel hex end of the hunter wrench into the radius adjustment screw.
A 90 degree arc would be a quarter circle sprinkler.
Adjusting the arc and radius of a rotor is an easy task.
How to adjust a hunter pop up sprinkler head step 1.
By pressing the nozzle fit it inside the opening and do it.
The first step is to opt for the best nozzle for the purpose.
Find the right hand limit of travel.
Turning the adjustment screw clockwise more than five full turns may result in a lost radius adjustment screw.
There are two adjustments that can be made on rotors arc and radius.
To adjust the sprinkler head arc follow this procedure.
Mike a hunter technical support representative demonstrates flushing a spray sprinkler upon installation adjusting the arc adjusting the radius cleaning the filter and installing a check valve.
Locate the adjustment socket at the top of the head and tune it to the right.
How to adjust hunter sprinkler heads head to head coverage.
The degrees of coverage of a sprinkler from one side of pattern to the other.
Most residential rotors are adjusted the same way.
Turn the screw clockwise into the stream of water to decrease the radius or counterclockwise to increase the radius.
Turn the sprinkler head to the left until it lines up with the left side of the garden or lawn then squeeze one of the clamps and rotate it until its against the tab extending down from the sprinkler head.
No comments:
Post a Comment