Loosen the set screws. You must release the tension on the garage door springs before attempting adjustment or replacement.
Look for a reddish cone on the torsion spring.
How to adjust garage door springs.
Take note of the notches and screws that hold the torsion spring in place.
These are the steps you need to take in order to adjust the springs.
Prepare to adjust the tension.
Open the door so you release the tension and support the door.
Tips for adjusting side mounted springs.
It should be placed on the left hand side of the torsion spring and placed away from the garage doors center.
How to adjust a torsion spring garage door step 1.
Locate the winding cone.
Repeat on the other side.
Secure the door with clamps so it doesnt roll while you work.
Release the tension on the springs by opening your garage door all the way and securing it in place with a c clamp.
Hold the garage door in this position by attaching a c clamp to the track at a point below the lowest door roller wheel.
How to adjust a garage door spring adjusting torsion springs close the garage door.
This is accomplished by opening the garage door as fully as possible until it hits the stop bolt on the track.
Locate a reddish color cone around the spring.
Get another metal rod of the same size.
Next get hold of one of the tension rods and push it into the first notch.
Tighten the set screws.
Pull the emergency release cord.
Take a wrench to loosen the two screws on the cone.
Use a metal rod to stick in the first notch of the cone.
Then disconnect any existing safety cables and remove them away from the door springs.
No comments:
Post a Comment